How to configure Ethernet network topology in canoe network based access mode

For the automotive network bus before the emergence of vehicle Ethernet , Whether it's LIN still CAN For example , They are all connected in series on a bus ECU node , such “ Multiple nodes on a channel ”,CANoe Channel based mode can be used Channel-based access Configure the network topology of the bus

With the widespread application of vehicle Ethernet in Automotive Network , The channel based mode is no longer applicable to the communication mode of vehicle Ethernet . The most remarkable sign of Ethernet communication is its switch Switch, The exchange is based on MAC Address forwards packets , This is also the data packet transmission mode of vehicle Ethernet

therefore Vector In the latest version, the switched network of Ethernet is introduced CANoe in （VN5620 and VN5650）, The network access mode to Ethernet is in addition to channel based Channel-based access Outside , Another port based Network-based access

Of course ,Network-based access There is no rigidity , Only switched networks can be used , It's compatible TAP and Direct connection Two network modes

Hardware Configuration

Have a look first CANoe Configuration of hardware side , It mainly creates different types of LANs and the allocation of physical ports

Segment

Segment Can be used for planning Network-based access In mode CANoe Network topology type created in hardware .Segment There are two types of ：Switch and Link. among Link It is divided into TAP and direct connection

Further explanation ：

Support Network-based access Of CANoe Hardware device , Can be in CANoe Create LAN in software , add to Segment（Switch or Link）&#x