How to set jewelry label paper

　　 Recently, several users have asked us , How to design jewelry labels in the label software . Xiaobian checked the Internet , The label of jewelry is different from the label paper we used in the past , The commonly used jewelry labels are divided into those with tail and those without tail ： The label size with tail is 25*75mm, Those without tails are usually 30*36mm, These two sizes are common universal sizes . The users who consult us use label paper with tail , How to set the label paper in the barcode software , The following will be a detailed introduction to .

　　 First open the barcode label software , Create a new label , Set according to the size of the label paper , Set the width and height of the label to 75mm and 25mm.

　　 The label in Figure 1 has two... Side by side , You can use a ruler to measure , The width measured is 30mm, Then divide it into two equally , That is, every 15mm. In the software, we use a ruler to segment .

　　 Using text tools , Rounded rectangle and bar code tool design label content . It should be noted here that we generally make horizontal versions , Here we need a vertical version , Just set the rotation angle on the right side of the software .

　　 Use the same method to complete the content of another part . The content direction of the two parts is relative . And pay attention not to exceed the scope of the ruler .

　　 Through the above settings , We have made a jewelry label . For this special label paper , We need to measure the dimensions , Pay attention to the display range of label paper when designing and making in the software , You can use the ruler tool .