Connect the local browser to the laboratory server through mobaxterm

Doing it oatpp When the project is , In the lab. Linux Under the server ,git Code for , Just run the code .oatpp When setting the port , The settings are 8000. Used on the server curl http://localhost:8000 Commands can produce results {"statusCode":200,"message":"Hello World!"}. However, I take it for granted that on my own computer Google Input directly from the browser localhost:8000, This is definitely not the result , Because my computer is not connected to the lab server .

The laboratory server is the terminal equipment used by everyone MobaXterm, Refer to the information on the Internet for operation .

About MobaXterm Go online to download this by yourself .

First of all, you need to know about the lab server ip What is it? , The input terminal ifconfig You can view it ,eno2 Ethernet inet The address is ip Address .

The second step ： Click on the toolbar Tools Medium MobaSSHTunnel（port forwarding）, This is the following interface ：

Click on the bottom left corner New SSH tunnel, It is shown as follows ：

After filling in all the Save, The interface appears again ：

Set the address to be accessed by your local browser , Set the loopback address here 127.0.0.1 namely localhost.

Click so start Button You can start testing ！

Browser input http://localhost:18000 What is displayed is that I pass the command through the laboratory server terminal curl http://localhost:8000 The results are consistent .

Note that one is 8000, One is 18000, Of course, you can set the same port