Cannot activate inspection type when SAP retail uses transaction code mm41 to create commodity master data?

SAP RETAIL Use transaction code MM41 Inspection type cannot be activated when creating commodity master data ？

stay SAP RETAIL Play in the system QM（Quality Management） modular , Is it possible to ？ Of course . What's special , The method of activating the inspection type of commodity master data is quite special . This article is to explain this particularity .

1, Execute transaction code MM41 Create a commodity master data 755, Get into Logistic:DC After view ,

Click button ‘Quality Management’, Get into QM After the view , As shown in the figure below ,

Only Display Insp.data. The inspection type cannot be activated normally .

2, and SAP In the manufacturing system MM01 When creating a new material , Get into QM After view ,

Click on Insp.setup Button , You can activate the inspection type for the material , Here's the picture ：

Why is that ？ Should not SAP RETAIL about QM What are the special setting requirements of the module ？

3, After the check , There are the following SAP Note For reference .

1923139 - MM41, MM42 - Defining inspection type for articles (IS-R) is not possible (QA291, MH091)

1923139 - MM41, MM42 - Defining inspection type for articles (IS-R) is not possible (QA291, MH091) | SAP Knowledge Base Article

4, In the transaction code MM41 Save the commodity number first in the 755,

And then execute QA08, Attempt to activate inspection type ,

Enter the item number 755, factory NMDC, perform , Enter the following interface ,

Select it , Click save ,

System prompt ：1 material were processed. succeed ！

Use transaction code MM43 Look at the quality management view data of this commodity ,

You can see its inspection type The relevant data , As shown in the figure below ：

So the conclusion is , stay SAP RETAIL In the system , stay MM41 When creating commodity master data , The inspection type cannot be activated directly , And in MM42 The inspection type cannot be activated in the transaction code , Only through transaction code QA08 To activate QM Type of inspection . This is also a SAP IS-RETAIL The uniqueness of the system

notes ： The of this paper is based on SAP S4HANA 1909 Completed on version of the system .

- End -

Written in 2022-219