Garbled code of SecureCRT, double lines, double characters, unable to input (personal detection)

Important note ： The software settings include 1 Current connection settings ,2 default setting . So many people can't solve the problem after setting it in the correct way ！

The connection settings are as follows , It is only after you have successfully connected the serial port that the following flag is set , If the serial port connection fails, you cannot set

  If you click here to set, your current serial port settings , In short , The next time you open a new serial port, you may still make an error . And the following Global Set this as the default , When set here , There will be no problem with the next setup .

Underneath The statement Set the explanation ：

Modify default all Default As shown in the picture ：

  Underneath Unable to input Set the explanation ：

  Cancel the red check above to enter . In addition, the following red is to save the serial port settings , When checked , Next time, you can directly enter the set serial port without setting . If you don't know how to find the last comment ！

  The following input is Double line return Set the explanation ：

When we enter enter once but enter twice , Remove the red check in the figure below

 

   The following input is Two line character Set the explanation ：

When we input one character but two characters , Remove the red check in the figure below